Abadal 15.9 B3848 Code:

OBD-II Diagnostic Body (B) Trouble Code

Trouble In Abadal 15.9 B3848 Possible Cause

The most likely cause of Abadal 15.9 B3848 code being stored is a defective automatic transmission cooler control valve or valve position sensor. Other causes may include corroded, open, or shorted wiring or connectors, a loose control module ground strap, or broken ground wire.

Common Symptoms For Abadal 15.9 B3848

  1. He individual alpha numeric codes may also be obtained by removing the appropriate valve cover and physically retrieving it
  2. This signal is systematically forwarded to affected control modules that utilize the data to accomplish various other tasks
  3. Intermittent conditions can prove to be quite a challenge to diagnose and in extreme cases may have to be allowed to worsen before a correct diagnosis can be made. If the fuel shutoff valve has not been deactivated by a collision, use the digital volt/ohmmeter to test voltage and ground signals at the valve itself
  4. As exhaust temperature decreases (with the engine off), circuit resistance increases and the feedback voltage signal to the PCM decreases

Similar Problems

Computer And Auxiliary Outputs
IC Circuit High Voltage
Kick-Down Switch Failed Short

Abadal 15.9 B3848 Troubleshooting

If this is the case with the code, you will be hearing very loud noises, like explosions, from the rear of the vehicle upon acceleration. Firstly check the carburetor to ensure that the fuel and air combination are properly balanced. If these settings are correct, then thoroughly inspect the distributor cap for any cracks or hairline splits, as this can produce a backfire. Move on to the spark plugs and ensure that they are clean and undamaged and inspect the engine gaskets for any sign of damage, as they are responsible for ensuring the correct gas exchange within the engine. Abadal 15.9 B3848 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Abadal 15.9 B3848 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.